[Getdp] GetDP: a problem about init and show surface values

[戴炜锋]

Hi,
  I have a problem about getdp:

  I use the thermal static/transient equations and choose some boundary
conditions for my simple box model.
But I find:
(1) Static problem: Assign T0 on top and assign T1 on bottom (Surface). But
in the post-processing views, I cannot see the surface value (all equal to
zero!). However the calculation is OK because the volume value is shown
rightly.
(2) Maybe the same reason to (1). In transient problem: If I set a initial
value on the volume (and surfaces), I will find that the surface radiation
boundary condition doesn't work and surface values equal to zero, too!

My model and project files are attached here.

Thank you very much !
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/getdp/attachments/20110601/623daa2c/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: SimpleTest.tar.gz
Type: application/x-gzip
Size: 905403 bytes
Desc: not available
URL: <http://www.geuz.org/pipermail/getdp/attachments/20110601/623daa2c/attachment.gz>