Hello,
I am trying to import a IGES file and gmsh cannot open it. The only output I see in terminal is a segmentation fault.
Are there any tricks to remove the error and import the file?
Here is the header part of the .igs file:
S 1
/COM,ANSYS RELEASE 10.0 UP20050718 11:16:44 11/05/2007 S 2
/NOPR S 3
/PREP7 S 4
/TITLE, S 5
BFUNIF,TEMP,_TINY S 6
KUSE,0 S 7
TIME,0.00000000 S 8
TREF,0.00000000 S 9
ALPHAD,0.00000000 S 10
BETAD,0.00000000 S 11
DMPRAT,0.00000000 S 12
CRPLIM,0.100000000,0 S 13
CRPLIM,0.00000000,1 S 14
NCNV,1,0.00000000,0,0.00000000,0.00000000 S 15
NEQIT,0 S 16
ERESX,DEFA S 17
ACEL,0.00000000,0.00000000,0.00000000 S 18
OMEGA,0.00000000,0.00000000,0.00000000,0 S 19
DOMEGA,0.00000000,0.00000000,0.00000000 S 20
CGLOC,0.00000000,0.00000000,0.00000000 S 21
CGOMEGA,0.00000000,0.00000000,0.00000000 S 22
DCGOMG,0.00000000,0.00000000,0.00000000 S 23
IRLF,0 S 24
!set_flag_to_prevent_offset_when_importing_FE_model. S 25
_CDRDOFF=1 S 26
/AUX15 S 27
IOPTN,YES,DEFA S 28
/GOPR S 29
!_END_OF_START S 30
1H,,1H;,,16Htucknov0507.iges, G 1
5HANSYS,22H 10.0 UP20050718,,,,,,,1.0,,,,,13H001105.111644, G 2
1.0000E-04,,,,9,,; G 3
128 1 0 0 0 0 0 000010001D 1
128 0 0 51 0 0 0 SURFACE 0D 2
126 52 0 0 0 0 0 000010501D 3
126 0 0 7 0 0 0B-SPLINE 0D 4
126 59 0 0 0 0 0 000010501D 5
126 0 0 23 0 0 0B-SPLINE 0D 6
126 82 0 0 0 0 0 000010501D 7
Thank you,
-Louis