[Gmsh] Creating a cylinder with a hole

[Ruth V. Sabariego]

The arcs should be smaller than Pi, otherwise there is a problem with indetermination. 
Have a look at the corrected attached file.
Regards,
Ruth


--
Dr. Ir. Ruth V. Sabariego
University of Liege, Electrical Engineering & Computer Science, 
Applied & Computational Electromagnetics (ACE),
phone: +32-4-3663737 - fax: +32-4-3662910 - http://ace.montefiore.ulg.ac.be/



On 08 Feb 2012, at 17:10, Orhan Shibliyev wrote:

> Hi all
>  
> I am trying to create a cylinder (with a hole) made up of two parts. Without extrusion, when it is meshed 2D, everything is OK however, when I extrude one of the surfaces, other half becomes deleted. Does not matter which half extruded first, the result is not what I want. I attached the geo file.
> <nnn.geo>_______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120209/fa6e8808/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: nnn.geo
Type: application/octet-stream
Size: 789 bytes
Desc: not available
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120209/fa6e8808/attachment.geo>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120209/fa6e8808/attachment-0001.html>