[Gmsh] anisostropic meshing / bamg algorithm

[Zenker, Dr. Matthias]

Hi,

it was written on this list that an anisotropic mesh can be achieved using the bamg algorithm. I have some questions:

1.      My 3D geometry consists of several layers stacked in z direction. Some of these layers are rather thin. I would like to have a mesh which is finer in z direction than in x and y direction. Can this be achieved using the bamg algorithm?
2.      How can I access this algorithm from the GUI? I did not find it in Options - Mesh.
3.      If not accessible from the GUI, how else can I use it?
4.      Is there any documentation available concerning this topic? I did not find anything in the gmsh manual (which is from October 2010 btw).

Thank you,

Matthias



_____________________________________________________________________
ERBE Elektromedizin GmbH
Firmensitz: 72072 Tuebingen
Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
Registergericht: Stuttgart HRB 380137

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120215/d0921b88/attachment.html>