[Gmsh] Combine 2 Objects in Mesh

[Zenker, Dr. Matthias]

Hi,

since your geometry seems to be rather simple, I would construct it directly in gmsh and make sure that the two volumes really use the same surface at the interface. Then the meshing should be no problem.

HTH,

Matthias

Von: William Seigfreid [mailto:weigfreid at silliam.com]
Gesendet: Montag, 9. Juli 2012 21:20
An: gmsh at geuz.org
Betreff: [Gmsh] Combine 2 Objects in Mesh

Hello,

I'm trying to mesh 2 objects that share a common interface.  I want them to share a common interface so that I can later assign different material properties to each part.

I have attached my test case stl files, my test geo file, and the compressed output when I run the geo file.  My current geo file doesn't create a mesh and I'm not sure how to proceed.  I would be very grateful if someone could help.

Thanks,
William


_____________________________________________________________________
ERBE Elektromedizin GmbH
Firmensitz: 72072 Tuebingen
Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
Registergericht: Stuttgart HRB 380137

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120713/e5a37a0f/attachment.html>