[Gmsh] Getting GMsh to ignroe shoreline points

[Jiplea, Marius]

Hello,

I've tried to use Compound Line and my syntax seems to be correct, but it seems that GMsh is throwing a sigmentation fault! I've attached a file to this e-mail. If you can have a look at it that would be great!

Cheers,
Mihai
________________________________________
From: gdmcbain at gmail.com [gdmcbain at gmail.com] on behalf of Geordie McBain [gdmcbain at freeshell.org]
Sent: Monday, August 06, 2012 4:20 PM
To: Jiplea, Marius
Cc: gmsh at geuz.org
Subject: Re: [Gmsh] Getting GMsh to ignroe shoreline points

2012/8/6 Jiplea, Marius <marius.jiplea11 at imperial.ac.uk>:
> Hello to all Gmsh users,
>
> At the moment, I am trying to use Gmsh to mesh the ocean surfaces and am
> experiencing an issue with it. I am extracting, out of some specially
> designed maps, the contours of altitude 0 (the shorelines, in a simpler way)
> and am writing them down to a .geo file (using a script). As a result, the
> .geo file will have a lot of points which are very close to each other (see
> first attached picture), but I'm happy with that.
>
> Afterwards, when I try and mesh the surface, the mesh is very fine near the
> shorelines because each point of the 0 contour gets included in the mesh
> (see second picture attached). The issue here is that I need to control how
> fine and coarse the mesh needs to be and I can't because it will always be
> very fine near the shorelines. Up until now, I couldn't get Gmsh to ignore
> the points. I know that I could use polygon simplification or just set a
> curved line to go near all the points and that might fix the issue, but I'm
> especially interested in any way of getting Gmsh to ignore the points on the
> shoreline.

Hello.  I think that if instead of using only two points per BSpline,
as on lines 3762 and on in uk_westeu.geo, you used more, then Gmsh
would not insist on having one mesh edge per pair of points.  You
might even be able to put all the consecutive two-point splines into a
single long spline.  The same thing works with Spline and even Line
(despite the documentation for the latter saying that a Line should
only have two points).

   http://geuz.org/gmsh/doc/texinfo/gmsh.html#Lines

Checking the documentation for Line again now I noticed that the
nearby description of the Compound Line command; that looks like it
might help your case too.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: ukmesh.geo
Type: application/octet-stream
Size: 352262 bytes
Desc: ukmesh.geo
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120807/2198f694/attachment.geo>