[Gmsh] GMSH to Elmer

[Dragon Age]

Greetings,

I think I figured it out; I looked at the actual file,and saw that the numbers were all out of sequence. Most likely from when I edited it, but did not reload the model. So I started from scratch, and it seemed to work this time around.

Thanks again, and best regards,

-DA



________________________________
 From: Dragon Age <dragonage36 at yahoo.com>
To: "gmsh at geuz.org" <gmsh at geuz.org> 
Sent: Tuesday, August 7, 2012 10:28 AM
Subject: GMSH to Elmer
 

Greetings,

I've just started using GMSH in conjunction with Elmer, and have encountered a problem for which I cannot find a solution. Whenever I import my GMSH model into Elmer, it ends up having only 1 surface, which is the entire model. So for example, say I make a cube in GMSH. I then 3D mesh it, then define physical groups by selecting each of the faces. I save as a MSH file with the default options (no boxes checked). I load it up into Elmer, and it only has 1 surface, which is the entire cube, irregardless of where I click.

What am I doing incorrect?

Thanks, and best regards,

-DA
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120807/ca086f2d/attachment.html>