[Gmsh] Meshing independent of number of points

[Wangshiraz]

Hi Geordie,

I tried your file and added a box around the spline loop. I want to cut a hole from the box with the spline. But with no success.

Is it posiible to use one spline loop as hole or I have to make the hole with two connected splines?

Regards,

Cean

> 
> From: Geordie McBain <gdmcbain at freeshell.org>
> To: Orxan Shibliyev <orxan.shibli at gmail.com>
> 
> If instead of a chain of Lines each defined by two Points you use a
> Spline or BSpline defined by multiple Points then those Points aren't
> necessarily used in the mesh, which I think is the behaviour you're
> after.  Try the attached example, running it with
> 
>   $ gmsh -2 -clscale 5 octagon.geo
> 
> URL: <http://www.geuz.org/pipermail/gmsh/attachments/20130130/f43c40a2/attachment-0001.geo>
> 

 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20130131/d5c1ba60/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: hole_with_a_spline.geo
Type: application/octet-stream
Size: 589 bytes
Desc: not available
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20130131/d5c1ba60/attachment.geo>