[Gmsh] Duplicate Nodes in extruded mesh

Zenker, Dr. Matthias Matthias.Zenker at erbe-med.com
Wed Dec 3 09:54:08 CET 2014


Hi,

I had a quick look at your file (in gmsh). It seems like there is no volume, and the lines are duplicated. I would propose that you check and fix this in Solidworks. Also you could try to export in STEP instead of IGS. AFAIK gmsh digests the STEP format better than IGS.

HTH,

Matthias

Von: Aaron Kiefer [mailto:AKiefer at accident-research.com]
Gesendet: Dienstag, 2. Dezember 2014 14:50
An: gmsh at geuz.org
Cc: Matt Suffern (msuffern at gmail.com)
Betreff: Re: [Gmsh] Duplicate Nodes in extruded mesh

Dr. Sabariego,

I'm writing as I found an old message from you regarding duplicate nodes in GMSH on a discussion forum.    I'm new to using GMSH and I was hoping that you could offer some advice on how to avoid this issue (after meshing, the duplicate nodes cause my FEA analysis to fall to pieces).   My methodology so far has been to create shapes in Solidworks via extrusion, then to import the .IGS file into GMSH and to mesh.  I've attached my .IGS file and my .MSH file in case you have time to look at them.  Thanks in advance for any counsel you can offer.

Aaron J. Kiefer MSME, PE
Accident Research Specialists, PLLC
1631 NW Maynard Road, Suite 101
Cary, NC 27513
Phone:  (919) 467-8134
Fax:        (919) 678-1261
Cell:        (919) 810-8429
Email:    akiefer at accident-research.com<mailto:akiefer at accident-research.com>
Web:      www.accident-research.com<http://www.accident-research.com/>
Email Confidentiality Notice:  The information contained in this transmission is confidential, proprietary, and/or privileged.  The message is intended for the sole use of the individual or entity to whom it is addressed.  If you are not the intended recipient, please be advised that any use, distribution, or copying of the message is strictly prohibited and may be subject to penalties,  If you received this transmission in error, please contact the sender immediately and delete this material from any computer.



_____________________________________________________________________
ERBE Elektromedizin GmbH
Firmensitz: 72072 Tuebingen
Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
Registergericht: Stuttgart HRB 380137

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20141203/8a1dd2e0/attachment.html>