[Gmsh] Subface and segment intersect

Christophe Geuzaine cgeuzaine at ulg.ac.be
Wed Jan 28 20:58:48 CET 2015


> On 09 Jan 2015, at 14:18, Jack <giacomolamberti90 at hotmail.it> wrote:
> 
> Could anyone please tell me what kind of error is "Found a subface and a segment intersect" when i try to mesh an stl file. I searched a lot but i didn't find any answear to this kind oh problems. Thank you.
> 

Your surface mesh auto-intersects, which will cause the 3D meshing algorithm to fail.

> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh

-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://www.montefiore.ulg.ac.be/~geuzaine