[Gmsh] R: Issues with OpenCascade
alessandro.vicini at sitael.com
Tue Oct 24 12:31:50 CEST 2017
Da: gmsh [mailto:gmsh-bounces at ace20.montefiore.ulg.ac.be] Per conto di Alessandro Vicini
Inviato: lunedì 23 ottobre 2017 12:35
A: gmsh at onelab.info
Oggetto: [Gmsh] Issues with OpenCascade
I find the following issues when using OpenCascade:
1) I start from the geometry of the attached test_00.geo: one cube, with a cubic hole;
2) Now if I want to apply a rotation to the inner cube (test_01.geo), I obtain that only the edges are rotated, and the original cube is conserved. This does not happen when the built-in geometry kernel is used (the applied rotation does not modify the surface loops that define the volume);
3) On the other hand, if I first apply the rotation (test_02.geo) and then define the volume (test_03.geo), the inner surface loop is not recognized as a closed volume.
Is there some way to work this out? Especially point 2) is an issue for me, as for my application I'd need to append the rotation command at the end of the geo file (i.e. after volume has been defined).
More information about the gmsh