[Gmsh] 3D meshing gmsh
gupta.aggraj at gmail.com
Mon Mar 30 07:08:06 CEST 2020
Thank you for the clarification.
Research Scholar | Electrical Engineering,
Indian Institute of Technology Madras
(M) +91 8427789957 <+91%2094440%2005772> | (P) +91 7376265173
On Mon, Mar 30, 2020 at 2:06 AM Christophe Geuzaine <cgeuzaine at uliege.be>
> > On 29 Mar 2020, at 16:17, Aggraj Gupta <gupta.aggraj at gmail.com> wrote:
> > Hi ,
> > I am new to gmsh software. I am using the software for meshing the
> sphere within the cube. I have attached the file below. As will be
> understood from the geo file that I have first created a cube and then made
> a sphere inside it. I did not delete volume as size of the sphere within
> the cube. I am giving two different material property to the cube as well
> as the sphere. Will it create a problem in this case? (as I am not getting
> my FEM results correctly!). If yes, can you please help me how to create
> the desired geometry so that it can get meshed in properly. I will be
> thankful to you if you could please pull me out of this. Looking forward
> for your reply.
> Your second volume has a hole, and should thus be defined using two
> surface loops.
> I recommend reading the tutorials before sending questions to the list.
> > Thanks
> > Regards,
> > Aggraj Gupta,
> > Research Scholar | Electrical Engineering,
> > Indian Institute of Technology Madras
> > (M) +91 8427789957 | (P) +91 7376265173
> > <sphere_cube.geo>_______________________________________________
> > gmsh mailing list
> > gmsh at onelab.info
> > http://onelab.info/mailman/listinfo/gmsh
> Prof. Christophe Geuzaine
> University of Liege, Electrical Engineering and Computer Science
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the gmsh