<div dir="ltr"><div dir="ltr">Dear all,<div><br></div><div>I generated a step-file in onshape and exported (in meter) to a step file.</div><div><br></div><div>When merging in GMSH it is imported in millimeters, and I was wondering how this can be changed.</div><div><br></div><div>I tried</div><div>Geometry.ScalingFactor = 0.001;<br></div><div>but it does not seem to have an effect in the geo file, and moreover I dont know if it will influence also the geometry I generate in .geo (aside from the imported one).</div><div><br></div><div>I adjusted the meshing in the .geo-file acordingly (millimeter), but in the would like to set up the entire meshing in meter rather than millimeter.</div><div><br></div><div>Could you tell me how to solve this? I attached both, the step file and the .geo file.</div><div><br></div><div>Thank you already in advance,</div><div>best regards,</div><div><br></div><div>Johannes</div><div><br></div></div></div>