<div dir="ltr"><div>Hi, gmsh community,</div><div><br></div><div>I created a simple case (beam fixed at both extremities) with a distributed load on a fraction of its upper surface.  I reproduce the short *.geo file:</div><div><br></div><div>SetFactory("OpenCASCADE");<br>Box(1) = {0, 0, 0, 100, 10, 10};<br>Rectangle(7) = {40,0,0,20,10,0};<br>Surface{7} In Volume{1};<br>surfaces[] = Boundary{Volume{1};};<br>Physical Volume("beam") = {1};<br>Physical Surface("left") = {surfaces[0]};<br>Physical Surface("right") = {surfaces[1]};<br>Physical Surface("load") = {7};</div><div><br></div><div>When I try to mesh it, I get the following error:</div><div>Error   : PLC Error:  A segment and a facet intersect at point<br>Error   : Invalid boundary mesh (segment-facet intersection) on surface 7, intersection (40,4.7255,6.14662e-11)</div><div><br></div><div>I think it comes from the fact that I am trying to impose a surface on another, but I can't find an easy way (rather than defining the geometry with Points, Lines, ... or determining the nodes on which I'd like to apply the loading from the msh file).</div><div><br></div><div>Could someone please point me the right direction ?</div><div><br></div><div>Thanks,</div><div><br></div><div>kind regards,</div><div><br></div><div>Vincent<br></div></div>