[Gmsh] recombine into all quads

[Marc Secanell]

Hi all,

I wanted to use GMSH to create quadrilateral meshes. In the past, you  
had an algorithm to recombine triangular meshes into All Quads,  
however, I've noticed that this option is not active anymore in the  
GMSH GUI. Is there a reason for such change? Also, is this a  
permanent change and All Quad meshes will not be supported anymore?

Thank you,

Marc
------------------------------------------------------------------------ 
------------------------
Marc Secanell Gallart, MASc
PhD Candidate
Institute for Integrated Energy Systems (IESVic)
Department of Mechanical Engineering, University of Victoria, Canada
Phone:          (250) 721 8662
Fax:               (250) 721-6051
e-mail:           secanell at uvic.ca
homepage:  www.me.uvic.ca/~msecanel
------------------------------------------------------------------------ 
--------------------------

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20070226/5b24d658/attachment.html>