[Gmsh] lower limit for characteristic length

[Zenker, Dr. Matthias]

I was wrong, it crashes also for cl=0.0005 (but after a looong time, and
with a runtime error).


________________________________

	From: gmsh-bounces at geuz.org [mailto:gmsh-bounces at geuz.org] On
Behalf Of Zenker, Dr. Matthias
	Sent: Monday, November 17, 2008 10:16 AM
	To: gmsh at geuz.org
	Subject: [Gmsh] lower limit for characteristic length
	
	

	Hi, 

	I wonder if there is a lower limit for the characteristic
length. I have a rather simple 2D geometry, and if I set the cl for just
two points to 0.0001, gmsh crashes during the meshing after having given
the error message "3 identical points in Qtest". The .gmsh-errors file
is not written. With cl=0.0005, this does not happen (but it takes
veeery long to compute the mesh).

	Best regards, 

	Matthias 

	----------------------------------------------------------------

	ERBE Elektromedizin GmbH 
	Dr.rer.nat. Matthias Zenker 
	Dipl. Phys. 
	Grundlagenentwicklung Technologie 
	Waldhoernlestrasse 17 
	D-72072 Tuebingen 
	Tel.: + 49 (0) 7071 - 755 226 
	Fax: + 49 (0) 7071 - 755 5226 
	E-Mail: <mailto:Matthias.Zenker at ERBE-med.de
<mailto:Matthias.Zenker at ERBE-med.de> > 
	URL: http://www.ERBE-med.de <http://www.ERBE-med.de>  
	----------------------------------------------------------------


	
	
	
 	  	  	

	ERBE Elektromedizin GmbH
	Firmensitz: 72072 Tuebingen
	Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
	Registergericht: Stuttgart HRB 380137
	



_____________________________________________________________________
ERBE Elektromedizin GmbH
Firmensitz: 72072 Tuebingen
Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
Registergericht: Stuttgart HRB 380137

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20081117/b02530db/attachment.html>