[Gmsh] Which file formats can be read by gmsh?

Christophe Geuzaine cgeuzaine at ulg.ac.be
Sun Feb 15 16:15:47 CET 2009


Zenker, Dr. Matthias wrote:
> Hi,
> 
> I have posted this question before, but it may have been overlooked:
> 
> Which file formats can be imported by gmsh?
> 
> I know that STEP and IGES can be read, and that DXF can't. I tried STL 
> which gave an error message, so I suppose that STL can't be read either. 
> I did not find a list of all supported file formats in the documentation.
> 

It's a bit difficult to list all the formats because it depends on how
Gmsh was compiled (many packages are optional).

The easiest way to figure out which formats your version of Gmsh can
read is to use File->Open and look at the list of available formats in
the dialog.


> Are there any import formats besides msh, geo, step, and igs?
> 
> Thank you,
> 
> Matthias
> 
> ----------------------------------------------------------------
> ERBE Elektromedizin GmbH
> Dr.rer.nat. Matthias Zenker
> Dipl. Phys.
> Grundlagenentwicklung Technologie
> Waldhoernlestrasse 17
> 72072 Tuebingen
> Phone + 49 7071 - 755 226
> Fax + 49 7071 - 755 5226
> _mailto:Matthias.Zenker at ERBE-med.de_
> _www.ERBE-med.de_ <file://www.ERBE-med.de>
> ----------------------------------------------------------------
> 
> 
> 
>   	  	 
> 
> ERBE Elektromedizin GmbH
> Firmensitz: 72072 Tuebingen
> Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
> Registergericht: Stuttgart HRB 380137
> 
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh


-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science
http://www.montefiore.ulg.ac.be/~geuzaine