[Gmsh] Coïncidence noeuds/points

[Gerard Fleury]

Hello,
Thank you for the answer!
Could you please then confirm that it is not possible to mesh
with Gmsh a single warped surface defined with more than 4 lines?

Regards

Gérard Fleury
INRS



-----Message d'origine-----
De : Christophe Geuzaine [mailto:cgeuzaine at ulg.ac.be]
Envoyé : mardi 2 juin 2009 16:24
À : gerard.fleury at inrs.fr
Cc : David.Colignon at ulg.ac.be; Vazquez Sabariego Ruth; Abdellatif
Belasri; gmsh at geuz.org
Objet : Re: [Gmsh] Coïncidence noeuds/points


Gerard Fleury wrote:
> Hello,
> 
> Thank you very much for you answer. This is logical but this is not a solution
> for my task.
> 
> The end task I want achieve is to mesh a surface, with some nodes located at some 
> given positions. These nodes may be located on the surface boundary (on the lines) as well
> as in the middle of the surface. 

For nodes on the boundary, you will have to split the lines... For nodes 
inside, use "embedded points":

    Point{mypoint} In Surface{mysurface} ;



-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science
http://www.montefiore.ulg.ac.be/~geuzaine