[Gmsh] Extrusion along parametric curve : update ?

[Zacharie De Grève]

Hello everyone,

Does anyone knows if it is now possible to extrude a surface along a 
particular curve in gmsh (in order to draw a conical coil for instance) ?

The same topic was posted on the list one year and an half ago approximately 
(http://www.geuz.org/pipermail/gmsh/2009/004162.html), and I was wondering if 
there is something new.

Thank you in advance.

Regards,

-- zdg
---------------------------------------------------
Ir Zacharie De Grève
PhD student - FNRS Research Fellow
Dept. of Power Electrical Engineering
University of Mons - Faculty of Engineering

Bd Dolez, 31
BE - 7000 Mons
Belgique
Tél : +32 65 374125
---------------------------------------------------