[Gmsh] higher order meshes

[Martin Genet]

Thanks a lot. I was doing exactly this and getting a Seg Fault, so I 
thought it wasn't the right way. But I cleaned my surface edges a 
little bit, and now it works perfectly. This is awesome. Thanks again! 
Martin

On Thu 02 May 2013 12:25:12 AM PDT, Jean-François Remacle wrote:
> gmsh -degree 3 your_input_file.geo
>
> JFR
> Le 2 mai 2013 à 07:09, Martin Genet
> <martin.genet at ucsfmedicalcenter.org
> <mailto:martin.genet at ucsfmedicalcenter.org>> a écrit :
>
>> Dear GMSH:
>>
>> I'm trying to mesh the volume inside an STL surface. No problem at
>> all when using first order elements, GMSH does such a perfect job at
>> remeshing the surface and then meshing the volume.
>>
>> I was wondering, is it possible to generate higher order meshes where
>> the additional nodes of the exterior faces stay on the original
>> surfaces? Would be awesome.
>>
>> Thanks for the comments/examples!
>>
>> Martin
>>
>>
>> _______________________________________________
>> gmsh mailing list
>> gmsh at geuz.org <mailto:gmsh at geuz.org>
>> http://www.geuz.org/mailman/listinfo/gmsh
>
> ------------------------------------------------------------------
> Prof. Jean-Francois Remacle
> Universite catholique de Louvain (UCL)
> Ecole Polytechnique de Louvain (EPL) - Louvain School of Engineering
> Institute of Mechanics, Materials and Civil Engineering (iMMC)
> Center for Systems Engineering and Applied Mechanics (CESAME)
> Tel : +32-10-472352 -- Mobile : +32-473-909930
>
>
>
>
>
>