[Gmsh] Problems with -renumber

[Christophe Geuzaine]

On 17 Jul 2013, at 21:18, Matthias Sedlmaier <Winterheart at gmx.de> wrote:

> Hello everybody,
> 
> I'm trying to renumber a *msh file and export it in abaqus *inp format.
> After starting GMSH with 
> >gmsh.exe mymeshfile.msh -renumber -3 -format auto -order 2 -o mymeshfile.inp
> i get the following output:
> <ahjfjaai.png>
> 
> Immediately after the last line GMSH crashes and the resulting *.inp file is empty.
> This also happens if the output format is set to *.msh.
> 
> I'm using GMSH 2.8.2 on Windows7 64bit. But the same behavior occurs also for V2.7.1.
> Without -renumber GMSH finishes the job as expected.
> 
> What i'm doing wrong?

Probably nothing. I'm not sure the -renumber is actually used by anybody; it should be tested/debugged...

Any help is welcome, although my personal preference would be for this whole part of the code (meshPartition.cpp) to be rewritten from scratch.


> Thank you very much for any hint.
> 
> Please find attached the meshfile.
> 
> Kind regards,
> Matthias
> <mymeshfile.zip>_______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh

-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://www.montefiore.ulg.ac.be/~geuzaine