[Gmsh] 3D mesh

[Zenker, Dr. Matthias]

Hi Philippe,

either mark everything you want to save as physical or check "save all (ignore physical groups)" when you save your mesh.

HTH,

Matthias

> -----Ursprüngliche Nachricht-----
> Von: Philippe Ackerer [mailto:ackerer at unistra.fr]
> Gesendet: Montag, 7. Oktober 2013 22:54
> An: gmsh at geuz.org
> Betreff: [Gmsh] 3D mesh
>
> Hi
> I missunderstood something. I plan to discretize a colmun.
> Could you explain me why only plan z=0 (nodes and elements) is stored in
> the .msh file ?
> I want also to identify the top surfaces, as I have done for the bottom
> surfaces (physical surface 101 and 'Dirichlet'). Any tips are welcome.
> I attached the file.
> Thanks and thanks a lot for this very helpfull mesh generator.
>
> Best regards
> Philippe
>
> --
> -------------------------------------------------------------
> Philippe ACKERER
> LHyGeS UMR 7517 CNRS-UdS Engees
> 1, rue Blessig
> 67000 STRASBOURG
> Tel: +33 (0)388 560 561



_____________________________________________________________________
ERBE Elektromedizin GmbH
Firmensitz: 72072 Tuebingen
Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
Registergericht: Stuttgart HRB 380137