[Gmsh] mesh a cylinder with hole

Mikhail Artemyev artemiev.mikhail at gmail.com
Fri May 2 16:09:48 CEST 2014

Hi Jean Pierre,

You're right, thanks for pointing that out.
Could you please share the code you were writing about?

Best regards,

On 05/02/2014 08:55 AM, gmsh-request at ace20.montefiore.ulg.ac.be wrote:
> hello Alberto and Mikail
> i do not agree with your method
> Surface(2) is not cylindrical, you ca see that if you increase r
> the intersection of two intersecting cylinder cannot be defined as a
> (plane) circle it is a 3 D curve like in the enclosed pics one large
> pipe intersected at 45? by a smaller one (smaller pipe not shown here)
> if you want i can post here the bit of code that do it
> jean pierre aubry