[Gmsh] Boundary of Compound Surface

[David Bernstein]

Hello Gmsh users, Does anyone know what the “Boundary” part of the Compound Surface command does?


Compound Surface ( expression ) = { expression-list } < Boundary { { expression-list }, { expression-list }, { expression-list }, { expression-list } } > ;

The problem I’m looking at is where two compound surfaces meet along a line (e.g. two cubes that share a single edge).  When Gmsh remeshes the surfaces it disconnects them along the shared line.  I’m wondering if the “Boundary” part of the command would address this.

Thanks,
Dave

This e-mail is covered by the Electronic Communication Privacy Act, 18 U.S.C. Section 2510-2521 and may be legally privileged. If you have received this transmission in error, please notify the original sender immediately by return e-mail or by telephone at the telephone number provided above and delete/trash the original message from your system. Thank you for your assistance. The information contained herein is confidential information provided only for the use of the individual or entity for whom it was intended. If the reader of this message received it in error, is not the intended recipient, or if an attachment is made in error, the reader is hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20150126/1e649beb/attachment.html>