[Gmsh] Extrude: inherit properties

[Christophe Geuzaine]

> On 20 Jan 2015, at 00:33, Jose A. Abell M. <jaabell at ucdavis.edu> wrote:
> 
> Hi,
> 
> I have some lines and surfaces which I am meshing with the transfinite algorithm. I need to extrude these such that the new lines and surfaces preserve the transfinite properties so I can mesh the resulting volume with the transfinite algorithm. Is it possible?
> 
> I am aware that the new (say vertical) side surfaces and lines will need to be assigned their own transfinite properties.
> 

Does Geometry.CopyMeshingMethod=1 fit the bill?

> Thanks!
> 
> --
> 
> Jose Abell 
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh

-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://www.montefiore.ulg.ac.be/~geuzaine