[Gmsh] Scaling problem

[David Colignon]

Hi,

Can you try with:

Geometry.ScalingFactor

     Global geometry scaling factor
     Default value: 1
     Saved in: General.OptionsFileName

Regards,

Dave

-- 
David Colignon, Ph.D.
1er logisticien de recherche
Université de Liège
ACE - Applied & Computational Electromagnetics
Sart-Tilman B28
10, Grande Traverse
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
http://www.ulg.ac.be/nic4

On 04/04/16 21:03, nbouvier at student.ulg.ac.be wrote:
> Hello,
>
> I was wondering if it's possible to change the scaling of every point defined in my code with a factor 100 immediately  in the .geo file?
>
> I am actually looking for an iterative methode as the scaling command of the Gmsh interface requires (if i'm right) to select each point one by one. The underlying problem of my situation is that i've already created one thousand of points...
>
> Kind regards.
>
> Nicolas Bouvier.
>
> _______________________________________________
> gmsh mailing list
> gmsh at onelab.info
> http://onelab.info/mailman/listinfo/gmsh
>