[Gmsh] problems (with opencascade?)

[Alessandro Vicini]

Yesterday I reported a problem I had when merging "farfield.geo" at the bottom of "test.geo" (both files attached). Now I found out that merging works if I switch to the built-in geometry kernel before (the geometry kernel is set to openCascade at the beginning of test.geo).
There are still two problems, though:

1) The points that are defined in FarField.geo are lost after the merging operation (I only get lines and surfaces, see attached picture where points are red. FarField.geo contains the geometry of the outer shell);
2) If I try to generate the 2D mesh, the code gets stuck in some infinite loop.

Could you please help with these issues? Thank you.

A.


-------------- next part --------------
A non-text attachment was scrubbed...
Name: Test.geo
Type: application/octet-stream
Size: 7953 bytes
Desc: Test.geo
URL: <http://onelab.info/pipermail/gmsh/attachments/20170922/290d0be5/attachment-0002.geo>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: FarField.geo
Type: application/octet-stream
Size: 3012 bytes
Desc: FarField.geo
URL: <http://onelab.info/pipermail/gmsh/attachments/20170922/290d0be5/attachment-0003.geo>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: complete.jpg
Type: image/jpeg
Size: 268133 bytes
Desc: complete.jpg
URL: <http://onelab.info/pipermail/gmsh/attachments/20170922/290d0be5/attachment-0001.jpg>