[Gmsh] Label Different Regions of Continuous Mesh, Geometry from .stp files

[Jeremy Theler]

On Wed, 2019-05-01 at 09:40 +0200, Christophe Geuzaine wrote:
> > 
> > I'm currently able to read the components into Gmsh and label them
> > with the `Physical Volume` syntax. The issue is that the surface
> > mesh elements at the boundaries do not line up with one another;
> > the elements in one component are not connected to the elements in
> > another.
> > 
> 
> You need to fuse the two surfaces: this can be achieved with the
> "fragment" operation - see attached file.

Would there be any difference by just using Coherence?


--
jeremy theler
www.seamplex.com