[Gmsh] Negative Jacobians in 2nd Order Mesh

[jeremy theler]

If you do not need curved elements set

Mesh.SecondOrderLinear = 1



--
jeremy theler
www.seamplex.com

On Fri, Sep 4, 2020, 11:22 Stephen Wornom <stephen.wornom at inria.fr> wrote:

> Tell the list if it removes the negative values.
> Thanks,
> Stephen
>
> ----- Original Message -----
> > From: "Christophe Geuzaine" <cgeuzaine at uliege.be>
> > To: "Nikhil Vaidya" <nikhilvaidya91 at gmail.com>
> > Cc: gmsh at onelab.info
> > Sent: Friday, September 4, 2020 2:19:36 PM
> > Subject: Re: [Gmsh] Negative Jacobians in 2nd Order Mesh
>
> >> On 4 Sep 2020, at 13:49, Nikhil Vaidya <nikhilvaidya91 at gmail.com>
> wrote:
> >>
> >> Hello,
> >>
> >> I have a geometry for which 1st order tetrahedral meshing works fine
> (with no
> >> negative jacobians). For the 2nd order case, I get a few negative
> jacobians.
> >> This problem does not go away even when I try to regularize the mesh or
> reduce
> >> mesh sizes in certain regions with small geometric features.
> >>
> >> Does someone have a suggestion?
> >
> > Try the high-order mesh optimizer: "-optimize_ho" on the command line.
> >
> > Christophe
> >
> >>
> >> Best regards,
> >> Nikhil
> >> _______________________________________________
> >> gmsh mailing list
> >> gmsh at onelab.info
> >> http://onelab.info/mailman/listinfo/gmsh
> >
> > —
> > Prof. Christophe Geuzaine
> > University of Liege, Electrical Engineering and Computer Science
> > http://www.montefiore.ulg.ac.be/~geuzaine
> >
> >
> >
> >
> > _______________________________________________
> > gmsh mailing list
> > gmsh at onelab.info
> > http://onelab.info/mailman/listinfo/gmsh
>
> _______________________________________________
> gmsh mailing list
> gmsh at onelab.info
> http://onelab.info/mailman/listinfo/gmsh
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://onelab.info/pipermail/gmsh/attachments/20200904/95849d8b/attachment.html>