[Gmsh] anisostropic meshing / bamg algorithm

Thu Feb 16 14:05:33 CET 2012

Hi Martin,

thank you for your answer. How do I define such an anisotropic mesh size field? Do you have a short example, or is this described somewhere? I did not find it in the Reference manual.

Best regards,

Matthias

Von: Martin Vymazal [mailto:martin.vymazal at vki.ac.be]
Gesendet: Donnerstag, 16. Februar 2012 12:17
An: gmsh at geuz.org
Betreff: Re: [Gmsh] anisostropic meshing / bamg algorithm

Hello Matthias,

you can use the bamg algorithm by calling 'gmsh -2 -algo bamg my_file.geo' from command line. For 3d anisotropic mesh, you do the same with '-3 -algo mmg3d'.

You need to supply a mesh size field which will tell the anisotropic algorithm in which direction to refine the mesh.

Best regards,

Martin Vymazal

On Thursday 16 February 2012 10:56:06 Zenker, Dr. Matthias wrote:

Hi,

does anyone have an answer to the question below?

It was said that an anisotropic mesh can be achieved using the bamg algorithm. I have some questions:

1.                   My 3D geometry consists of several layers stacked in z direction. Some of these layers are rather thin. I would like to have a mesh which is finer in z direction than in x and y direction. Can this be achieved using the bamg algorithm? If so, how?
2.                   How can I access this algorithm from the GUI? I did not find it in Options – Mesh.
3.                   If not accessible from the GUI, how else can I use it?
4.                   Is there any documentation available concerning this topic? I did not find anything in the gmsh manual (which is from October 2010 btw).

Thank you,

Matthias

----------------------------------------------------------------

ERBE Elektromedizin GmbH

Dr.rer.nat. Matthias Zenker

Dipl. Phys.

Grundlagenentwicklung / Fundamental Development

Waldhoernlestrasse 17

72072 Tuebingen

Germany

Phone + 49 (0) 7071 755 - 226

Fax + 49 (0) 7071 755 - 5226

E-Mail: <mailto:Matthias.Zenker at erbe-med.com>

URL: http://www.ERBE-med.com

----------------------------------------------------------------

_____________________________________________________________________
ERBE Elektromedizin GmbH
Firmensitz: 72072 Tuebingen
Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
Registergericht: Stuttgart HRB 380137

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20120216/35be70f0/attachment.html>