[Gmsh] Cut-Plane Mesh outlines

[Holger Schwaab]

Hi,

I'm using Gmsh as a post-processor for a 3D Hex user element. Often I 
just want to show 2D Contour which I obtain by the Plug-in "CutPlane". 
If I now draw the element outlines the original 3D-Hex Mesh is 
transformed to a 2D triangle mesh. Is where a option so that I generate 
a 2D Contour with the "old" Mesh outlines ?

Thanks

Holger Schwaab

-- 
_______________________________________________________________

     Holger Schwaab

     Karlsruhe Institute of Technology (KIT)
     Institute for Applied Materials

     Hermann-von-Helmholtz-Platz 1
     D-76344 Eggenstein-Leopoldshafen
     GERMANY

     Tel.:  +49 (0)721 608 23459
     Fax:   +49 (0)721 608 12347
     email: holger.schwaab at kit.edu
     WWW:   http://www.imf2.kit.edu

     KIT - University of the State of Baden-Wuerttemberg and National
           Laboratory of the Helmholtz Association
_______________________________________________________________