[Gmsh] Node sets for Abaqus inp file

[Christophe Geuzaine]

> On 06 Jan 2015, at 04:04, Cormac Flynn <Cormac.Flynn at wintec.ac.nz> wrote:
> 
> Is there a command line option for including groups of nodes when saving as an ABAQUS file, i.e. including *NSETS in the inp file?
> 

set "Mesh.SaveGroupsOfNodes=1;" in your script, or use -string "Mesh.SaveGroupsOfNodes=1;" on the command line


> Thanks in advance.
> 
> Regards,
> Cormac​
> This electronic mail transmission is intended for the named recipients only. It may contain private and confidential information. If this has come to you in error you must take no action based upon it, nor must you copy it or show it to anyone; please telephone or email the sender at Wintec immediately and return the original email. We cannot accept any liability for any loss or damage sustained as a result of software viruses. It is your responsibility to carry out such virus checking as is necessary before opening any attachment which may be included with this message.
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh

-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://www.montefiore.ulg.ac.be/~geuzaine