3d automesh

[S.K.Choi]

Dear sir,
Related with my last letter I'd like to add a few comments.
The model that I hope to analyse is so complex and has several small
rounds(i.e. small diameter such as 3mm, 5mm) so that I
must configurate this model approximately to have correct analytic
results.
So I think I have to obtain about 500,000 tetrahedron elements.
How can I obtain those automeshed data?
Please check my final geo file and then give me advise,if possible.

Thanks in advance,

Best regards,

S.K.Choi

*attachment---- final geo file



Christophe Geuzaine ??????:

> "S.K.Choi" wrote:
> >
> > *Attachments
> > #1. Cbsg2dsc.geo   :    2-dimensional file
> > #2. Vcb3dsc.geo    :    full 3-d file
> > #3. Origin.geo      :    a division of Vcb3dsc.geo / I assume this
> > division has wrong LC.
>
> Hello!
>
> I didn't receive any files attached to your e-mail... Could you send
> them again ?
>
> --
> Christophe Geuzaine
>
> Tel: +32-(0)4-366.37.10     mailto:Christophe.Geuzaine at ulg.ac.be
> Fax: +32-(0)4-366.29.10     http://www.montefiore.ulg.ac.be/~geuzaine