[Gmsh] New user question: different maximal mesh size for x, y, z?

Christophe Geuzaine cgeuzaine at ulg.ac.be
Sun May 31 10:19:14 CEST 2009


protoss lee wrote:
> Hi,
> I need to generate a mesh which has maximal size of 5 nm in x,y and in
> 1~2 nm in z.
> This was not possible with netgen, so I asked some colleagues and they
> suggested me to try gmsh.
> Is this possible?

If you get into trouble due to the small size you can always scale the 
geometry and/or the mesh after the fact...


> Thx
> Lee
> 
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh
> 
> 


-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science
http://www.montefiore.ulg.ac.be/~geuzaine