[Gmsh] Question about reclassify

[Christophe Geuzaine]

On 17/06/10 17:37, Martin Vymazal wrote:
> Hello,
>
> I would like to ask if it is possible to launch the 'reclassify' command
> from command line. I normally use it from the gui, but since all the
> other mesh processing is done using scripts, it would be nice if I could
> do this also without opening the gui.
>
> I have one more little question. Suppose I run reclassify, I get a lot
> of surfaces and I hide some of them by clicking in the gui. Is it
> possible to create a new geo/msh file which contains only entities
> currently set as visible? What I mean is that I don't want to save a
> file which is the original mesh with additional info about visibility,
> but I'd like to have a new file in which the 'invisible' parts are
> completely absent.
>

Hi Martin - No, but these would be two nice additions. Could file 
requests for enhancement in the bug tracking system? This will help us 
keep track of the ideas.


> Thank you.
>
> Best regards,
>
> Martin Vymazal
>
> ----------------------------------------------------------------
> This message was sent using IMP, the Internet Messaging Program.
>
>
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh
>


-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science
http://www.montefiore.ulg.ac.be/~geuzaine