[Gmsh] Now, I am lost :(

Christophe Geuzaine cgeuzaine at ulg.ac.be
Wed Feb 12 16:54:46 CET 2014


On 12 Feb 2014, at 14:41, Philippe Ackerer <ackerer at unistra.fr> wrote:

> Hi,
> Following my previous mail, I try to generate a prismatic mesh of a cylinder without the 'extrude' command to prescribe the identity value of the sides.
> I used Transfinite instructions without success (the 3D elements are not prisms - see attached file).
> 

Change

Recombine Volume {301}; // highly experimental stuff ;-)

into 

Transfinite Volume {301};

You'll probably want to use Extrude instead, though -- it's much easier.

> Any help is very welcomed. Thanks,
> Philippe
> 
> -- 
> --------------------------------------------------------------
> Philippe ACKERER
> LHyGeS UMR 7517 UdS-CNRS-Engees
> 1, rue Blessig
> 67000 STRASBOURG
> tel +33 (0)368 850 561
> -------------------------------------------------------------
> 
> <col3.geo>_______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh

-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://www.montefiore.ulg.ac.be/~geuzaine