[Gmsh] Extruding 2d mesh
iyer.arvind.sundaram at gmail.com
Wed Feb 15 18:12:13 CET 2017
I have a 2d (quad) mesh in .msh format. I wish to extrude this 2d mesh
perpendicular to its plane as layers to get a hex mesh.
Is there a way of doing this in gmsh?
Dr. Iyer Arvind Sundaram
The reasonable man adapts himself to the world; the unreasonable one
persists in trying to adapt the world to himself.
Therefore all progress depends on the unreasonable man
- George Bernard Shaw.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the gmsh