[Gmsh] R: Control points not cocircular

[Alessandro Vicini]

Thank you!

A.

-----Messaggio originale-----
Da: Christophe Geuzaine [mailto:cgeuzaine at ulg.ac.be] 
Inviato: mercoledì 6 settembre 2017 10:28
A: Alessandro Vicini
Cc: gmsh at onelab.info
Oggetto: Re: [Gmsh] Control points not cocircular


Hi Alessandro,

I fixed the bug. The spurious errors were issued because we tried to recompute curve parameters every time we transformed (rotated/translated) the control points; the parameter recomputation is now done once the whole list of points has been transformed.

Christophe

> On 6 Sep 2017, at 09:16, Alessandro Vicini <alessandro.vicini at sitael.com> wrote:
> 
> 
> Any help regarding the problem described below...? Thanks...
> 
> -----Messaggio originale-----
> Da: gmsh [mailto:gmsh-bounces at ace20.montefiore.ulg.ac.be] Per conto di 
> Alessandro Vicini
> Inviato: lunedì 4 settembre 2017 15:48
> A: gmsh at onelab.info
> Oggetto: [Gmsh] Control points not cocircular
> 
> 
> The attached geo file gives a number of "control points of circle [...] are not cocircular" errors.
> Anyway, the geo file is read and it works fine. The control points actually are cocircular, except perhaps for a small numerical tolerance.
> So my question is: how is it possible to avoid these being printed out as "errors"? Thank you.
> 
> Alessandro
> 
> _______________________________________________
> gmsh mailing list
> gmsh at onelab.info
> http://onelab.info/mailman/listinfo/gmsh

--
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine

Free software: http://gmsh.info | http://getdp.info | http://onelab.info