[Gmsh] R: command line options
alessandro.vicini at sitael.com
Fri Sep 21 14:56:36 CEST 2018
Ok, thank you, what I do not understand is how to do the 2d smoothing before the 3D mesh….
I have tried (ok, that’s trivial….):
Gmsh -2 –smooth 5 -3 –optimize
But this just starts with the 3D mesh…
Da: Ruth Vazquez Sabariego [mailto:ruth.sabariego at kuleuven.be]
Inviato: venerdì 21 settembre 2018 14:54
A: Alessandro Vicini
Cc: gmsh at onelab.info
Oggetto: Re: [Gmsh] command line options
You can get all the available options by typing in the command line:
2D mesh => -2
3D mesh => -3
gmsh -smooth number_steps
On 21 Sep 2018, at 14:47, Alessandro Vicini <alessandro.vicini at sitael.com<mailto:alessandro.vicini at sitael.com>> wrote:
I usually work interactively, and I go through the following steps to generate a 3D mesh:
1) 2D mesh;
2) Smoothing of the 2D mesh (repeated a few times);
3) 3D mesh;
4) Optimization of 3D mesh.
How would I carry out the same process from command line? Thank you.
gmsh mailing list
gmsh at onelab.info<mailto:gmsh at onelab.info>
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the gmsh