[Gmsh] problems (with opencascade?)

Christophe Geuzaine cgeuzaine at ulg.ac.be
Mon Sep 25 15:26:13 CEST 2017


Hi Alessandro,

There seems to be a little bug with "newp". As a workaround set

p1 = 1000;

in Farfield.geo and everything will be ok.

Christophe

> On 22 Sep 2017, at 08:59, Alessandro Vicini <alessandro.vicini at sitael.com> wrote:
> 
> 
> Yesterday I reported a problem I had when merging "farfield.geo" at the bottom of "test.geo" (both files attached). Now I found out that merging works if I switch to the built-in geometry kernel before (the geometry kernel is set to openCascade at the beginning of test.geo).
> There are still two problems, though:
> 
> 1) The points that are defined in FarField.geo are lost after the merging operation (I only get lines and surfaces, see attached picture where points are red. FarField.geo contains the geometry of the outer shell);
> 2) If I try to generate the 2D mesh, the code gets stuck in some infinite loop.
> 
> Could you please help with these issues? Thank you.
> 
> A.
> 
> 
> <Test.geo><FarField.geo><complete.jpg>_______________________________________________
> gmsh mailing list
> gmsh at onelab.info
> http://onelab.info/mailman/listinfo/gmsh

-- 
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science 
http://www.montefiore.ulg.ac.be/~geuzaine

Free software: http://gmsh.info | http://getdp.info | http://onelab.info




More information about the gmsh mailing list