[Gmsh] R: problems (with opencascade?)

[Alessandro Vicini]

In fact that's what I did in the meantime as a workaround.
I'll wait for the bug to be fixed, thank you!

A.

-----Messaggio originale-----
Da: Christophe Geuzaine [mailto:cgeuzaine at ulg.ac.be] 
Inviato: lunedì 25 settembre 2017 15:26
A: Alessandro Vicini
Cc: gmsh at onelab.info
Oggetto: Re: [Gmsh] problems (with opencascade?)


Hi Alessandro,

There seems to be a little bug with "newp". As a workaround set

p1 = 1000;

in Farfield.geo and everything will be ok.

Christophe

> On 22 Sep 2017, at 08:59, Alessandro Vicini <alessandro.vicini at sitael.com> wrote:
> 
> 
> Yesterday I reported a problem I had when merging "farfield.geo" at the bottom of "test.geo" (both files attached). Now I found out that merging works if I switch to the built-in geometry kernel before (the geometry kernel is set to openCascade at the beginning of test.geo).
> There are still two problems, though:
> 
> 1) The points that are defined in FarField.geo are lost after the 
> merging operation (I only get lines and surfaces, see attached picture 
> where points are red. FarField.geo contains the geometry of the outer 
> shell);
> 2) If I try to generate the 2D mesh, the code gets stuck in some infinite loop.
> 
> Could you please help with these issues? Thank you.
> 
> A.
> 
> 
> <Test.geo><FarField.geo><complete.jpg>________________________________
> _______________
> gmsh mailing list
> gmsh at onelab.info
> http://onelab.info/mailman/listinfo/gmsh

--
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine

Free software: http://gmsh.info | http://getdp.info | http://onelab.info