[Gmsh] mesh generation

Stefano Zinna stefano.zinna at uniheat.it
Thu Nov 13 16:49:10 CET 2008


Hello.

This is the step file of the section i have sent. Let me know if it is 
what you need. thanks.

regards.
Stefano



Ruth V. Sabariego ha scritto:
> Could you send just the section of TOLOMEO LED you used to generate 
> the mesh?
> If in the imported file there are only surfaces, you should add a 
> surface loop to consider the volume and be able to mesh it.
>
> Regards,
> Ruth
>
> Stefano Zinna wrote:
>> Dear Sirs.
>>
>> I have a problem when crossing from surface mesh to volume mesh in Gmsh.
>> I'm using Gmsh 2.2.4 version. It seems that Gmsh is not able to 
>> recognize volumes in the surface mesh attached (56.stl.tar.gz). Also 
>> i attach the starting CAD file (TOLOMEO LED.stp.tar.gz) where i took 
>> a section to create the surface mesh.
>> Let me know if you can help me. Many thanks
>>
>> best regards,
>> Stefano Zinna
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>> gmsh mailing list
>> gmsh at geuz.org
>> http://www.geuz.org/mailman/listinfo/gmsh
>
> -- 
> Dr. Ir. Ruth V. Sabariego
> University of Liege, Institut Montefiore,
> Dept. of Electrical Engineering & Computer Science, 
> Applied & Computational Electromagnetics (ACE),
> Sart Tilman Campus, Grande Traverse, 10 (B28), B-4000 LIEGE, Belgium
> phone: +32-4-3663737 -- fax: +32-4-3662910 -- http://elap.montefiore.ulg.ac.be/

-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: Solid_56.step
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20081113/8e46cbd2/attachment.step>