[Gmsh] gmsh 2.2.5 failing to mesh

[Ruth V. Sabariego]

Your model seems to have only lines and points, that's why you don't see 
a 2D/3D mesh.
The 1D mesh is done correctly.

Ruth

Roland Tollenaar wrote:
> Hello,
>
> I have a model which fails to mesh. gmsh says its meshing it (console) 
> but nothing happens. (0s)
>
> I have seen this same behaviour with STL models previously and simply 
> assumed that gmsh could not handle stl files.
>
> However this is a step model of a type that gmsh previously did mesh 
> well.
>
> I have attached the model.
>
> Kind regards,
>
> Roland
> ------------------------------------------------------------------------
>
> _______________________________________________
> gmsh mailing list
> gmsh at geuz.org
> http://www.geuz.org/mailman/listinfo/gmsh

-- 
Dr. Ir. Ruth V. Sabariego
University of Liege, Institut Montefiore,
Dept. of Electrical Engineering & Computer Science, 
Applied & Computational Electromagnetics (ACE),
Sart Tilman Campus, Grande Traverse, 10 (B28), B-4000 LIEGE, Belgium
phone: +32-4-3663737 -- fax: +32-4-3662910 -- http://elap.montefiore.ulg.ac.be/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.geuz.org/pipermail/gmsh/attachments/20081116/3d60f0c7/attachment.html>